Hillside S-Bend right

Built By: Bob Myers

Description: Description:Single track S-Bend. This module brings the track from the front to the rear of a single track module this module is 372mm long (6 x 62mm) rather than standard single length 310mm (5 x 62mm). This allows the curve to use standard Unitrack parts (481mm radius x 15 degree, 2 x 64mm straight, 481 x 15).

This was my first 168mm deep module — a proof of concept and demonstration of the inherent reversibility. Obviously I liked it well enough to continue.

This shows the module from the side that is in front when used as part of the Hillside set.

This shows the module reversed.