Typical Method - Quarter Inch Material

The following plans are for a single module and a 180o degree corner (end cap) module. The #60 holes referenced in the drawings are pilot holes for nails that are glued in place. The plans specify Luan but 1/4" plywood or MDF could be used. Since the creation of the plans the builder has switched his preference to MDF. This method typically requires power tools, such as a table saw, to accurately cut the necessary pieces from larger stock.


TTRAK%20MODULE.pdf
plainModule2.jpg

Above: The single module with a coat of paint and track installed is now ready for scenery.


The following blueprint is for a 180 degree corner module.

TTRAK-C1.pdf
Unless otherwise stated, the content of this page is licensed under Creative Commons Attribution-ShareAlike 3.0 License